Training and laboratory stand "Installation of elements of protective grounding, zeroing, disconnection devices"

4 388,00 $

Features

Specifications

  1. Structurally, the complex consists of an assembly table and additional sets of elements placed on the assembly field. The assembly table is assembled from a steel profile with an integrated worktable to pand a pull-out box for storing work tools. Above the work surface there is a built-in electrical power supply module of the stand and a frame made of aluminum profile with a perforated mount in panel installed on it. Features of the built-in electrical module Protected sockets: Power source 1~220V, 50Hz,3 A 2 pcs. Power source 1-36 V, 50 Hz , 3 A 2 pcs. Power supply 1~12, 50 Hz , 3 A 2 pcs. Regulated power source 2…30 V, 3 A 1 pc.

    1.Electrical installation complex. The replaceable panel allows you to mount the test devices in the electrical panel, to connect the electrical load with a cable channel. It is possible to check single-phase and three-phase devices.

    2.The replaceable panel allows you to carry out the following laboratory work:

    1. Study of the principle and verification of a single-phase circuit breaker.
    2. Studying the principle and checking the three-phase automatic switch.
    3. Study of the principle and verification of a single-phase protective disconnection device.
    4. Study of the principle and verification of the three-phase protective disconnection device.

     

    On the panel are placed: electric metal shield; 3 position switch; straight cartridge E27; cable channel; block of clamps; DIN-rail, on which are fixed: automatic switches (single-phase and three-phase); protective disconnection devices (single-phase and three-phase).